About Us
Hydro-Tap Service, Inc. started in 1982 by Sonny Kyle. Our company is a professional tapping contractor with special equipment and expertise to meet all industrial and municipal needs. Prior to starting our company, Sonny's experience in piping, valves, taps, and line-stops dates back to 1973. During this time, he was the Branch Manager of A.C. Pipe, Inc. which is a pipe, valve, industrial pump, etc. supplier.
We were established to satisfy the demand for pipeline drilling, tapping, and stopping. We serve from New York to Georgia. We have complete military clearance and are Washington Suburban Sanitary Commission (WSSC) approved. Our home headquarters is located in Chesterfield, Virginia. Listed below are our services that are available to you, our respected customer:
Taps "We Tap It" Any type of main: hot, wet, chemical, and gas, low pressure, high pressure, or non-pressure. Any size: 3/4" through 84" "We Tap Anything" from 700°F to 1440 psi. Specialized equipment to provide all Industrial Taps.
Stops "We Stop It" Low pressure or high pressure, sizes 3/4" through 84". If you have leaky pipes, valve not holding, pipe breaks, no valves, pipe relocation, etc. STOP IT by calling us today!
Add a Valve Is a copper,
steel, or pvc emergency shut off device which is used to install an initial
valve, add a new valve, or remove a defective valve. We furnish and install on
hot or cold water including hot or chilled H2O Glycol Systems under pressure
from 0 through 250 psi/17 bar max., on L, K, or *Metric copper tubing, without
shutting off the water, in 60 minutes or less. 1/2" through 2".
*Specify
Cores "We Core It" Complete line of concrete coring and Kor-N-Seals. Up to 48" diameter.
All excavations must be OSHA safe.
Questions/Comments
Call Us at 804-590-1981
Copyright © 2008 Hydro-Tap Service, Inc.
All rights reserved.